Recoton/Advent AW810 Tune The Speaker, More Helpful Information, Adjust the speaker as follows

TUNE THE SPEAKER

Adjust the speaker as follows:

Turn On and Tune the Speaker

1.Use the speaker Power ON-OFF/Volume Control Knob (C) to turn the speaker “ON.” Tuning Indicator Light (A) will illuminate red.

2.Turn the Tuning Control Knob (B) until the Tuning Indicator Light changes color to green, indicating the speaker is tuned to the signal from the transmitter. With the volume up, you should now be able to hear the audio source.

3.Adjust Volume (C) as desired.

	Tuning Control Knob (B)	Power ON-OFF/Volume
Tuning Indicator Light (A)
		Control Knob (C)

Note: After fine tuning, interference in the form of static and/or distortion can sometimes be heard. If this occurs, confirm correct transmitter/speaker adjust- ments and indicators. If the problem persists, refer to the TROUBLESHOOTING section of this manual.

MORE HELPFUL INFORMATION

About Fixed-Level Outputs

A fixed-level, or line-level audio output is considered ideal since it provides an audio signal unchanged by adjustments to the audio source (stereo, etc.) volume control.

Hint: Fixed-level audio outputs from stereo receivers/amps will typically be desig- nated as Tape, Tape 1, and Tape 2 outputs, DAT (digital audio tape) outputs, VCR audio output connections, and auxiliary audio outputs. Tape, Tape 1, Tape 2 and DAT outputs are usually marked as ‘TAPE OUTPUT,’ ‘TAPE OUT,’ ‘TAPE REC,’ or

7