MAINTENANCE
DOOR GLASS
FAN MAINTENANCE
REPLACEMENT
YourFPIinsertissuppliedwithhightemperature, 5mmNeoceramceramicglassthatwillwithstand the highest heat that your unit will produce. In the event that you break your glass by impact, purchase your replacement from an authorized FPI dealer only, and follow our
WARNING: do not operate appli- ance with the glass front removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service per- son.
Bay Glass Removal
1)Remove the door from the unit and place on a soft surface to prevent scratching.
2)Remove the nuts holding the glass retainers in place.
3)Remove the glass retainers (sides, top and bottom).
4)Replace the glass. The glass must have gasketing around it.
5)Reverse the previous steps, replace the retainers and fasten with the nuts but do not over tighten, as this can break the glass.
6)Replace door on the stove and check the seal.
Flush Glass Replacement
Slide old glass out of the side frames and replace with new glass.
Ifyourfanrequiresmaintenanceorreplacement, access to the fan is through the plate on the rear wall of the fi rebox. NOTE: the unit MUST
NOT be operated without the fan access panel securely in place.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring error can cause improper and dangerous opera-
To remove fan:
1)Turn the unit off and allow it to cool to room temperature.
2)Unplug or disconnect power source to stove.
3)Remove glass front (see page 11).
4)Remove logs.
5)Remove brick panels.
6)Remove the Grate by removing the screws on each side of the grate.
Remove the 2 screws holding the
grate in position.
7)Remove the Burner Tray by removing the screws on each side of the tray. Push the tray to the left and lift up.
Remove the 2 screws,
push Burner Tray to the left, and lift off.
8)Remove the 11 screws holding the Access Panel in place.
9)Remove the Fan Air Duct by removing 4 screws, 2 per side.
10)Unplug the black wires from the fan motor (from inside the stove).
11)LiftFanAssemblyoffofthe2pins,tipforward and pull through fi rebox opening.
12)Disconnect green wire from power cord.
Replacing fan:
Reverse above steps. Hint for pushing fan down onto pins - rub a bit of dish soap on the grommet so it will slide more easily onto the pin. Check to make sure the fan is seated properly on the pins, this is very important- try to move the fan back and forth, there should be no noise, if there is check that the grommets haven't come loose.
When replacing the Burner Tray, slide the aera- tion adjustment rod through the opening in the front of the Valve Assembly.
Aeration Adjustment Rod
24 | FPI |
