INSTALLATION
3)Open Bottom Louvers.
4)Remove the bottom glass trim. Discard both top & bottom glass trim.
5)Replace the glass and secure with the two glass clips. Do not over tighten as this could
break the glass. | Slots |
Make sure the glass is centered.
Side Hook
6)Insert side hooks on the double screen door into the 4 slots between the faceplate and the glass and lower assembly into the locking position. Push down fi rmly with both hands to lock into place.
Push Screen
Door down
firmly
to lock into
place.
Insert Screen Door
hooks into the 4 slots between the faceplate and the fl ush door.
This heater does not require a 120V A.C. sup- ply for operation. In case of a power failure, the burner switch and the optional remote control/ thermostat will continue to operate. However, a 120V A.C. power supply is needed for the fan/blower operation.
WIRING DIAGRAM
Caution: Ensure that the wires do not touch any hot surfaces and are away from sharp edges.
CAUTION: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous opera-
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded
14 | FPI |