HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L
7. Operation
■STARTING ENGINE
pulling the rope, or remove the spark plug and dry it.
OP1
OP2
OP3
OP4 |
[HTZ2460] |
[HTZ2460L] |
[CHTZ2460] |
[CHTZ2460L] |
WARNING
•The cutting head will start moving upon the engine starts.
1.Feed fuel into the fuel tank and tighten the cap securely.
2.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start moving upon starting of the engine.
3.Push the primer pump several times until overflown fuel flows out in the clear tube. (OP1)
4.When the engine is cool, move the choke lever to the closed position. (OP2)
(1)primer pump
(2)choke lever
(3)close
(4)open
(5)ignition switch
(6)RUN
(7)STOP
(8)throttle lever
5.Set the ignition switch to the “RUN” position. Release the throttle lever and make sure it is fully back. (OP3)
6.While holding the unit firmly, pull out the starter rope quickly until engine fires. (OP4)
IMPORTANT
•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.
7.Move the choke lever to the open position. And pull out the starter rope quickly to restart engine.
8.Allow the engine to warm up for a several minutes before starting opertion.
NOTE
1.When restarting the engine immediately after stopping it, leave the choke open.
2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat
OP5
OP6
■STOPPING ENGINE (OP3)
1.Release the throttle lever and run the engine for a half minute.
2.Shift the ignition switch to the “STOP” position.
IMPORTANT
•Except for an emergency, avoid stopping the engine while pulling the throttle lever.
NOTE
•If the engine won't stop when setting the ignition switch to the stop position, close the choke lever and stop the engine.
In this case, please repair the machine at your nearest servicing dealer.
■RUNNING IN THE ENGINE
IMPORTANT
•During the first 20 working hours, do not use the
■ADJUSTING IDLING SPEED
•Before adjusting the carburetor, clean the air filter and warm up the engine. (OP5)
(1) air filter
•Idle screw is adjusted in order to ensure a good safety margin between idle running and clutch engagement. (OP6)
(1) Idle screw
WARNING
•With the engine idling (3000 rpm), the blade should not move. We recommend that you have the dealer or an authorised mechanic carry out any carburetor adjustments.
WARNING
•Weather conditions and altitude may effect carburation.
