2.Orient the Stabilizer (57) so that the indents around the holes are on the bottom. Attach the Bench Leg (2) to the Stabilizer with two M8 x 50mm Carriage Bolts (53) and two M8 Nylon Locknuts (17). Do not tighten the Locknuts.
3.Attach the Bench Frame (1) to the Bench Leg (2) with two M8 x 39mm Bolts (52), two M8 Washers (32), and two M8 Nylon Locknuts (17). Make sure that the bolt heads fit inside the hexago- nal holes in the Bench Frame. Do not tighten the Locknuts.
4.Attach the Bench Frame (1) to the Crossbar (3) with an M8 x 54mm Bolt (43) and an M8 Nylon Locknut (17); and with two M8 x 52mm Bolts (18), two M8 Washers (32), and two M8 Nylon Locknuts (17). Do not tighten the Locknuts.
5.Lubricate an M10 x 65mm Bolt (44) with grease. Attach the Leg Lever (5) to the Bench Leg (2) with the Bolt and an M10 Nylon Locknut (51). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily.
2 |
|
2 |
|
17 |
|
17 | |
Indents | 57 |
| |
53 |
|
3 |
|
52 |
|
32 | 1 |
| |
32 |
|
17 |
|
2 |
|
4 |
|
32 | 17 |
43 |
|
1 |
|
| 3 |
17 |
|
18 |
|
5 |
|
51 |
|
5 | 44 |
| Grease |
| 2 |
6
