6.Attach the Backrest Tubes (12) to the Backrest (20) with four M6 x 38mm Screws (42) and four M6 Washers (49). Do not tighten the Screws.
7.Slide the Adjustment Bar (13) into the Uprights (4) from the side shown. Turn the Adjustment Bar so that the locking pin wraps around the Upright.
Grease an M10 x 138mm Bolt (45). Attach the Backrest Tubes (12) to the Bench Frame (1) with the Bolt, two M10 Washers (50), and an M10 Nylon Locknut (51). Do not overtighten the
Locknut; the Backrest Tubes must be able to pivot easily.
Tighten the M8 Nylon Locknuts (17) used in steps
8.Orient the Seat (21) as shown and attach it to the Bench Frame (1) with four M6 x 15mm Screws (41).
9.Insert a Pad Tube (19) into a hole in the Leg Lever (5). Slide two Foam Pads (23) onto the Pad Tube.
Repeat this step with the other Pad Tube (19).
6 |
|
|
|
| 20 |
|
|
| 12 |
| 49 |
|
|
| |
|
| 12 |
|
| 49 | 42 |
|
|
| 49 |
|
| 42 |
|
|
7 |
|
|
|
| 4 |
|
|
| 20 |
| Locking |
51 | 50 |
| |
| Pin | ||
|
|
| 4 |
| 12 |
| 13 |
|
| 50 | |
|
|
| |
| 1 | 45 |
|
8 | 21 |
|
|
|
|
| |
| Wide |
|
|
| End |
|
|
|
| 1 |
|
|
| 41 |
|
|
| 41 |
|
9 |
|
|
|
23 | 5 |
| |
| 19 |
|
|
|
| 23 |
|
|
| 19 |
|
7
