
ASSEMBLY
Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of | ||
the packing materials until assembly is completed. | and a rubber | |
In addition to the included tools, assembly requires an adjustable wrench | ||
mallet | . |
|
See the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 25; the number following the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not found in the parts bag, check to see if it has been preassembled.
M4 x 16mm | M4 x 22mm | M4 x 25mm | M6 x 13mm | M8 x 19mm | M6 x 20mm Patch | |
Screw | Screw | Screw | Shoulder | Shoulder | Screw | |
|
|
|
| Screw | Screw |
|
M8 x 19mm Patch | M8 x 25mm Patch |
| Bolt Set |
| ||
|
|
| ||||
Screw |
| Screw |
|
|
| |
M10 Nylon |
| M6 Split | Small M8 | M10 Split | Wave Washer | Large M8 |
Locknut |
| Washer | Washer | Washer | Washer |
1.Identify the Front Stabilizer (63), which has Wheels (27) attached to one side. Attach the Front Stabilizer to the front of the Frame (1) with four M8 x 25mm Patch Screws (73).
1 | 73 |
| |
| 73 | ||
|
| ||
| 63 | 73 | |
27 | 1 | ||
|
5