11.Identify the Left Handlebar (7). Attach the Left Handlebar to the left Pivot Arm (20) with four M8 x 13mm Button Screws (90) as shown.
Attach the Right Handlebar (6) to the right Pivot Arm
(20)in the same way.
12.Position the Front Left Pivot Cover (21) and the Rear Left Pivot Cover (31) over the left Pivot Arm (20) as shown. Attach the Left Pivot Covers with an M4 x 16mm Round Head Screw (91) and two M4 x 16mm Screws (89).
Attach the Front Right Pivot Cover (29) and the Rear Right Pivot Cover (not shown) over the right Pivot Arm (not shown) in the same way.
13.While another person holds the Console (17) near the Upright (4), attach the Upper Wire Harness (58) and the Pulse Sensor Wire (25) to the corresponding con- sole wire harnesses. Then, attach the Console to the Upright with six M4 x 16mm Screws (89), being care- ful not to pinch the wires.
Attach the Upright Cover (22) to the Upright (4) with two M4 x 16mm Round Head Screws (91).
14.Plug the Power Cord (56) into the Power Receptacle (70) at the rear of the elliptical exerciser.
11 |
|
|
|
| 7 |
|
|
|
|
| 6 |
| 90 |
| 20 |
|
|
| |
|
| 20 |
|
|
| 90 |
|
12 |
|
|
|
91 |
| 31 |
|
|
|
| 29 |
89 |
|
| 21 |
|
|
| |
|
| 20 |
|
|
|
| 89 |
13 |
| 22 |
|
|
| 17 | |
|
|
| |
91 |
|
|
|
|
| 25 |
|
89 |
|
|
|
89 |
|
| 58 |
|
| 4 | |
|
|
| |
14 |
|
|
|
|
|
| 70 |
|
|
| 56 |
15.Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
8
