5.Attach a Pedal Assembly (39) to the Left Pedal Arm (9) with five M4 x 16mm Screws (89).
Attach the other Pedal Assembly (not shown) to the Right Pedal Arm (not shown) in the same way.
6. Remove the two Pivot Shafts (10) from the two Pivot |
Arms (not shown). Next, identify a Union Set (86), and |
remove the screw from the barrel. Apply a small |
amount of grease to the outside of the barrel. |
Slide an M8 x 18mm Washer (93), a Wheel Cap (53), |
and a 30mm Spacer (87) onto the barrel of the Union |
Set (86). While another person aligns the indicated |
holes in the Left Pedal Assembly (39), a Pedal Arm |
Wheel (52), and a Pivot Shaft (10), insert the barrel |
through all of the holes. Then, slide another 30mm |
Spacer (87) onto the barrel. |
Next, slide an M8 x 18mm Washer (93) and a Wheel |
Cap (53) onto the screw of the Union Set (86), and |
tighten the screw into the barrel. |
Attach the other Pivot Shaft (not shown) and the other |
Pedal Arm Wheel (not shown) to the Right Pedal |
Assembly (not shown) in the same way. |
7. While another person holds the Upright (4) near the |
5
39
9
89
89
6
| 10 | 93 | 86 |
|
| ||
|
| 87 |
|
| 87 | 53 | |
|
| ||
93 |
| 52 | 39 |
86 |
|
| |
|
|
| |
| 53 |
|
|
Grease | Align |
|
|
these |
|
| |
|
|
| |
| holes |
|
|
Frame (1), connect the Upper Wire Harness (58) to the |
Extension Wire Harness (59). Slide the Upright onto |
the top of the Frame, being careful not to pinch the |
Wire Harnesses. |
Attach the Upright (4) to the Frame (1) with two M8 x |
47mm Button Screws (110), an M8 x 25mm Button |
Screw (100), and three M8 Split Washers (85). |
7
4
1
Do not pinch the wire harnesses during this step.
85
110
85 
100
58
59
6
