8.While another person holds the Pulse Sensor Bar (26) near the Upright (4), connect the upper pulse wires to the lower pulse wires. Insert the excess wire into the Upright.
Orient the Pulse Sensor Bar (26) as shown. Attach the Pulse Sensor Bar to the Upright (4) with four M8 x 16mm Button Screws (94), being careful not to pinch the wires.
9.Identify the Front Center Pivot Cover (27). Attach the Front Center Pivot Cover to the Frame (1) with four M4 x 16mm Screws (89).
Next, identify the Rear Center Pivot Cover (28). Attach the Rear Center Pivot Cover to the Frame (1) with four M4 x 16mm Screws (89).
Attach the Water Bottle Holder (23) to the Upright (4) with four M4 x 16mm Screws (89).
10.Apply a small amount of the included Teflon® lubricant to a paper towel, and rub a thin film of the lubricant onto both of the Pivot Shafts (10). Next, apply a small amount of grease to the axle in the Upright (4).
Then, slide a 5mm Spacer (35) onto each end of the axle in the Upright (4).
Next, slide the two Pivot Arms (20) onto the Pivot Shafts (10), and turn the Pivot Arms so the flanges are facing away from the elliptical exerciser. Then, slide the Pivot Arms onto the ends of the axle in the Upright (4); use a rubber mallet, if necessary.
Slide an M8 x 23mm Washer (103) onto an M8 x 25mm Patch Screw (123). Attach the left Pivot Arm (20) to the left end of the axle with the Patch Screw.
Attach the right Pivot Arm (20) to the right end of the axle in the same way.
8 |
|
| 26 |
| Upper |
| |
|
|
| |
| Pulse |
| 94 |
| Wire |
| |
| 94 |
| |
|
|
| Upper |
|
|
| Pulse Wire |
|
|
| 94 |
Lower |
|
|
|
Pulse Wire |
| Lower | |
|
| ||
|
| Pulse Wire | |
4 |
|
|
|
9 |
|
|
|
28 | 89 |
| 89 |
|
| ||
|
|
| |
89 |
|
|
|
|
| 89 |
|
|
|
| 23 |
4 |
| 89 | 89 |
|
|
| |
|
|
| 27 |
10 |
|
|
|
4 |
|
|
|
|
|
| Grease |
Grease |
|
| |
35 |
|
|
|
Flange |
|
| 20 |
123 |
| 10 |
|
103 |
|
| 10 |
20 |
|
|
|
Lubricate |
|
|
|
7
