Reebok Fitness RBE09950 manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two

included hex keys, assembly requires a phillips screwdriver , two adjustable

wrenches , a rubber mallet , and pliers .

Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled.

M4 x 16mm M4 x 16mm Round		M8 Split		M8 x 18mm
Screw (89)–30 Head Screw (91)–6		Washer				M8 x 23mm	M8 x 25mm
				Washer (93)–4
		(85)–11
						Washer (103)–2	Washer (119)–2
M8 x 13mm Button	M8 x 16mm Button		M8 x 20mm Button		M8 x 25mm Patch		M8 x 25mm Button
Screw (90)–8	Screw (94)–4		Screw (118)–2			Screw (123)–2	Screw (100)–1
M8 x 47mm Button Screw (110)–2				M8 x 65mm Button Screw (95)–8
			Union Set (86)–2

1.Orient the Front Stabilizer (3) as shown. Attach the Front Stabilizer to the Frame (1) with four M8 x 65mm Button Screws (95) and four M8 Split Washers (85).

Next, attach the Front Shield (38) to the Front Stabilizer (3) with two M4 x 16mm Round Head Screws (91).

Then, tighten the two Frame Cushions (106) into the underside of the Frame (1).

1	91
	38
	1
	3
		85
	85	106
		95
	95

4