Reebok Fitness RBE09950 manual Maintenance and Troubleshooting, Pulse Sensor Troubleshooting

MAINTENANCE AND TROUBLESHOOTING

Inspect and properly tighten all parts of the elliptical exerciser regularly. Replace any worn parts immedi- ately.

For smooth
operation of the
elliptical exer-
ciser, inspect
and clean the
ramp regularly	Ramp
using a soft
cloth and mild
detergent.
Other parts of
the elliptical
exerciser can
also be cleaned
in this way. Keep liquids off the console. Never use
abrasives or solvents.

PULSE SENSOR TROUBLESHOOTING

If the handgrip pulse sensor does not function proper- ly, see step 6 on page 12.

HOW TO CALIBRATE THE INCLINE SYSTEM

If the elliptical exerciser’s incline system is not working properly, activate the calibration process by following the steps below.

HOW TO MOVE THE ELLIPTICAL EXERCISER

Stand behind the elliptical exerciser and hold the indi- cated handle firmly. Lift the handle until the elliptical exerciser can be moved on the front wheels, and carefully move the elliptical exerciser to the desired location. Then, carefully lower the elliptical exerciser.

Due to the size and weight of the elliptical exercis- er, use extreme caution while lifting, moving, and lowering it.

Wheel

Lift Here

1. Hold down the Start button and the increase but-

ton to the left of it at the same time for about five

seconds. Note: Numbers may appear in the dis-

HOW TO LEVEL THE ELLIPTICAL EXERCISER

	plays; disregard these numbers.
2.	Press the Programs button. Note: A combination of
	letters and numbers will appear in the display.
3.	Press the 30° Quick Ramp button. The ramp will
	rise to the highest position and then move down to
	the lowest position.
4.	Press the Programs button three times. The con-
	sole will then be in the normal operating mode and
	the elliptical exerciser will be ready for use.

If the elliptical exerciser rocks during use, turn one or both of the leveling feet under the front stabilizer until the rocking motion is elimi- nated.

Leveling Foot

22