MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the exercise cycle regularly. The exercise cycle can be cleaned with a soft, damp cloth. To prevent damage to the con- sole, keep liquids away from the console and keep the console out of direct sunlight.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries should be replaced. See assembly step 6 on page 8 for replacement instructions. If the console does not display your heart rate when you use the handgrip pulse sensor, see step 5 on page 13.
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise cycle
does not sit flat on your floor, turn one or both of the leveling feet until the exercise
cycle is level.Leveling 
Feet 
HOW TO ADJUST THE BELT
If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the belt may need to be adjusted. To adjust the belt, the pedals and side shields must first be removed. Using an adjustable wrench, turn the right pedal counter- clockwise and remove it. Then, turn the left pedal counterclockwise and remove it. Remove the screws from the right side shield, and then carefully remove the side shields.
Loosen, but do |
| |
not remove, the |
| |
three indicated |
| |
screws (A). |
| |
Insert the shaft |
| |
of a screwdriver |
| |
downward | 28 | |
between the | ||
| ||
Pulley (22) and |
| |
the idler (B). Pull |
| |
the top of the | 22 | |
screwdriver | B | |
toward the rear | A | |
of the exercise |
| |
cycle until the |
|
Belt (28) is tight. Then, tighten the three screws.
Reattach the side shields, and then reattach the ped- als. To attach the pedals, turn the right pedal clock- wise and turn the left pedal counterclockwise.
17
