HOW TO SELECT MILES OR KILOMETERS
measurement, first remove the access door from the back of the console. Locate the Reset button and the
The console can display speed and distance in either miles or kilome- ters. The letters “MPH” or “KMH” will appear in the display to show which unit of mea- surement is selected. To
change the unit of
Reset | Switch |
Button |
|
switch inside the console. Slide the switch up or down to select miles or kilometers, and then press the
Reset button. Reattach the access door to the back of the console.
M AINTENANCE AND | T ROUBLESHOOTING |
Inspect and tighten all parts of the exercise cycle reg- ularly. The exercise cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console
out of direct sunlight.
PULSE SENSOR TROUBLESHOOTING
•Avoid moving your hands while using the pulse sen- sor. Excessive movement may interfere with heart rate readings.
Inspect and prop- erly tighten all parts of the exer- cise cycle regular- ly. Make sure to keep the indicated screws tight (there are two screws on each side). In addition, make
sure to keep the pedals tightened.
Keep these |
screws tight |
• | If your heart rate is not shown when the pulse sen- |
| sor is used, press the resistance – button to reset |
| the display. |
• | Do not hold the metal contacts too tightly; doing so |
| may interfere with heart rate readings. |
• | For the most accurate heart rate reading, hold the |
| metal contacts for about 15 seconds. |
• | For optimal performance of the pulse sensor, keep |
| the metal contacts clean. The contacts can be |
| cleaned with a soft |
HOW TO LEVEL THE EXERCISE CYCLE
abrasives, or chemicals. |
If the exercise cycle does not sit flat on the floor, turn one or both of the leveling pads until the exercise cycle is level.
Leveling |
Pads |
CONSOLE TROUBLESHOOTING
If the console display flickers while you are changing the resistance setting, increase your pedaling pace.
11
