11. TROUBLESHOOTING |
11. TROUBLESHOOTING
11.TROUBLESHOOTING
WARNING!
If you cannot solve a problem with the following solutions, do not attempt to repair it by yourself. Turn off the printer, then contact your TOSHIBA TEC representative for assistance.
When a problem occurs during operation, the status indicator will blink or light. Refer to the following troubleshooting guide and take corrective action.
Status | Cause | Corrective action | ||
Indicator | ||||
|
| |||
|
| Media end | Load a new media roll. | |
|
|
|
| |
|
| The media cover is | Close the media cover completely. | |
|
| open. |
| |
|
|
|
| |
|
| The printer is jammed | Turn off the printer, remove the jammed | |
|
| with media. | media, and | |
|
|
| correctly. | |
|
|
|
| |
Blinks in | The print head element | Contact a TOSHIBA TEC service | ||
is broken. | representative for repair. | |||
Red |
|
|
| |
| The print head | Open the media cover and allow the | ||
|
| |||
|
| temperature reached | print head to cool. | |
|
| the upper limit of the |
| |
|
| operating temperature. |
| |
|
|
|
| |
|
| A communication error | Check that the interface cable is | |
|
| occurred. | connected firmly. Check the | |
|
|
| communication parameters. | |
|
|
|
| |
|
| Flash ROM write error | Open the media cover and close it | |
|
| or erase error | again. If the error occurs again, remove | |
|
| occurred. | the battery pack and ask TOSHIBA | |
|
|
| TEC representative for repair. | |
|
|
| 11- 1 | |
