Toshiba B-SP2D owner manual Connecting the Serial Interface Cable

7. CONNECTING THE SERIAL INTERFACE CABLE EO1-33038

7.CONNECTING THE SERIAL INTERFACE CABLE

4)Secure the serial interface cable to the printer with the enclosed cable clamp and SMW-3x8 screw as shown in the picture below.

NOTE: Allow the cable between the connector and the cable clamp to slack. Failure to do this may damage the internal wire or connector terminal.

5)Put the enclosed ferrite core on the serial interface cable between the connector and the cable clamp.

Ferrite Core

Serial Interface Cable

SMW-3x8 Screw

Cable Clamp

NOTE: Use the serial interface cable model CABLE-SP2D-S or equivalent which meets the following specifications:

-1.2 m long

-Shield type

-When in use, the enclosed ferrite core is attached.

-Printer side connector is 8-pin Male MINI DIN type.

7- 2