5. LOADING THE MEDIA |
5. LOADING THE MEDIA
•Strip issue
1.Unroll the label roll a little and remove a label.
2.Close the media cover completely. Make sure that the media cover release catches snap back into position.
Media Cover
Release Catch
Media Cover
Release Catch
3.When the label has been loaded in the power on state, the label will be automatically fed to adjust the print start position (only when the feed gap sensor is selected).
NOTE: Be sure to take up any slack in the media roll before closing the media cover. An incompletely closed cover will cause a media skew, print position misalignment, poor print quality, paper jam, etc.
5- 3
