Table B-2. Configuration Manager Messages (continued)
Message | Probable Cause | Corrective Action |
|
|
|
ERROR: Could not read | An attempt to read the | See the chapter titled “Getting Help” in your |
NVS, Error=Internal | NVRAM failed. | Diagnostics and Troubleshooting Guide for |
Error Code. |
| instructions. |
|
|
|
ERROR: Failed NVS | An attempt to write to | Run the Dell Diagnostics to verify the integrity |
write. Error=Internal | NVRAM failed. | of your system NVRAM. See your Diagnostics |
Error Code. |
| and Troubleshooting Guide for instructions. |
|
| If you are unable to determine the cause of the |
|
| error, see the chapter titled “Getting Help” in |
|
| your Diagnostics and Troubleshooting Guide for |
|
| instructions. |
ERROR: Failed to acti- vate device, CSN=Card Select Number.
A Plug and Play expansion card could not be activated.
Use the following procedure:
1.Exit the ICU and turn off your system.
2.Remove the Plug and Play expansion card that could not be activated.
Follow steps 2 through 6 of “Removing an Expansion Card” in Chapter 6, and then return to this procedure.
3.Reinstall the Plug and Play expansion card.
Follow steps 5 through 9 of “Installing an Expansion Card” in Chapter 6, and then return to this procedure.
If you still receive the error message, contact the manufacturer of the Plug and Play expan- sion card for assistance.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.
