Dell Mini Tower System Remove all card configurations from, Reboot your system, As they arise

Table B-2. Configuration Manager Messages (continued)

Message Probable Cause Corrective Action

WARNING: Could not configure Plug and Play Card Name.

The card(s) mentioned are not fully configured due to resource conflicts.

If you do not know the allowable resource values for your Plug and Play or PCI expansion card, use the following procedure to locate and resolve the resource conflict:

WARNING: Could not		1.	Remove all card configurations from the
configure PCI device,
			ICU.
ID=DeviceID.
			See “Removing a Card” in Chapter 3 for
Failed to configure			instructions.
Number of Total Count		2.	Reboot your system.
Plug and Play ISA			The ICU should automatically configure
devices. Use your sys-
tem’s configuration			your Plug and Play or PCI expansion card.
utility to resolve		3. Add the ISA expansion cards back into
conflicts. Press any			the ICU, resolving any resource conflicts
key to continue.			as they arise.
			See “Adding a Listed Card” in Chapter 3
			for instructions.
		If your Plug and Play or PCI expansion card is
		not automatically configured when you reboot
		the system with all other cards removed, you
		should contact the manufacturer of the card or
		see the chapter titled “Getting Help” in your
		Diagnostics and Troubleshooting Guide.
WARNING: Boot Device	One of the devices is	Perform the following procedure:
conflict detected!	attempting to use one or	1.	Start the ICU.
CSN=Card Select Number	more resources assigned to
		2.	Identify the card marked config err.
Error=Error.	the system’s boot device.

This card is attempting to use one or more resources required by the system’s boot device.

3. Follow the procedure for the preceding error message in this table.

NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.

B-8 Dell OptiPlex GXa Mini Tower Systems Reference and Installation Guide