HOW TO INSTALL THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver included with the chest pulse sensor.
1.See assembly step 4 on page 5, and remove the two M4 x 25mm Screws (not shown) and the Bookrack (55).
Next, look under the console and locate the three indi- cated screws (not shown). Remove the three screws.
Do not remove the screws attaching the Console to the Handlebar Post (6).
2.Carefully lift the top of the Console (9) as shown. Using the two small screws included with the chest pulse sen- sor, attach the receiver to the indicated plastic posts on the Console. Make sure that the receiver is turned exactly as shown. Connect the wire on the receiver to the indicated wire on the Console.
See step 1 above. Lower the top of the Console (9). Make sure that no wires are pinched. Reattach the top of the Console with the three screws removed in step 1. See assembly step 4 on page 5, and reattach the Bookrack (55) with the two M4 x 25mm Screws (not shown). Note: The remaining wires included with the chest pulse sensor may be discarded.
1 |
|
|
9 |
| 55 |
|
| |
Screws |
| 6 |
2 |
| 9 |
|
| |
| Screws | Wire |
|
| |
|
| Receiver |
|
| Posts |
EXERCISE CYCLE OPERATION
HOW TO ADJUST THE POSITION OF THE SEAT | HOW TO ADJUST THE PEDAL STRAPS |
For effective exercise, the seat should be in the proper position. As you pedal, there should be a slight bend in your knees when the pedals are in the farthest position. To adjust
the seat, pull the seat knob and
slide the seat car- riage to the desired position. Release
the seat knob and slide the seat car- riage back and forth slightly until it locks into posi- tion.
To adjust the pedal straps, first pull the ends of the straps off the tabs on the pedals. Adjust the straps to the desired positions and press the ends of the straps back onto the tabs.
Strap |
Tab |
8
