2.Attach the Rear Stabilizer (3) to the rear of the Frame (1) with two M10 x 105mm Carriage Bolts (74) and two M10 Nylon Locknuts (63).
3.While a second person holds the Handlebar Post (6) near the Frame (1) as shown, connect the Upper Wire Harness (16) to the Lower Wire Harness (58).
Carefully slide the Handlebar Post (6) onto the Frame (1); be careful to avoid pinching the Wire Harnesses (16, 58). Attach the Handlebar Post to the Frame with four M8 x 25mm Button Screws (27) and four M8 Split Washers (65).
4.The Console (9) requires four “D” batteries (not included); alkaline batteries are recommended. Press the indicated tab on the battery cover and remove the cover. Press four batteries into the bat- tery clips; make sure that the batteries are orient- ed as shown by the markings inside of the bat- tery clips. Then, reattach the battery cover.
5.Insert the Bookrack (55) into the slots in the Console
(9). Attach the Bookrack to the Console with two M4 x 25mm Screws (66). Be careful not to pinch the wires in the Console.
2 |
|
|
1 | 63 |
|
|
| 63 |
|
| 3 |
74 |
|
|
3 |
|
|
| 65 | 6 |
27 |
| |
|
| |
|
| 65 |
65 |
|
|
16 |
| 27 |
58 |
| 65 |
|
| |
1 |
|
|
4 |
|
|
|
| 9 |
Battery |
|
|
Cover |
|
|
|
| Batteries |
5 |
|
|
55 |
|
|
|
| 66 |
9 |
|
|
5
