10.Attach the console assembly with four 3/8" x 1" Bolts (4) and four 3/8" Star Washers (8). Start all four Bolts before tightening any of them. Note: The Left Accessory Tray (105) and the Right Accessory Tray (114) are replaceable. If these parts become dislodged from the Console Base (98), simply press them back in.
11.Identify the Latch Assembly (76). Remove the tie from the end of the tube. Make sure that the sleeve has been slid over the indicated hole and that the Latch Knob (108) is locked into the hole.
Pull on the sleeve to make sure that it is locked into place.
12.Raise the Frame (55) to the position shown.
Have a second person hold the Frame until this step is completed.
Orient the Latch Assembly (76) so that the large barrel and the Latch Knob (108) are in the posi- tions shown. Attach the lower end of the Latch Assembly to the bracket on the Base (85) with a 3/8" x 1 3/4" Bolt (3) and a 3/8" Nut (11).
Attach the upper end of the Latch Assembly (76) to the bracket on the Frame (55) with a 3/8" x 1 3/4" Bolt (3) and a 3/8" Nut (11). Note: It may be necessary to move the Frame back and forth to align the Latch Assembly with the bracket. Lower the Frame (55) (see HOW TO LOWER THE TREADMILL FOR USE on page 21).
10 |
|
|
|
105 |
|
| 114 |
8 | 98 |
| |
|
| ||
4 |
|
|
|
| 8 |
| Console |
|
|
| Assembly |
11 | 108 |
|
|
|
|
| |
Tube | Hole |
| |
Sleeve | 76 |
| |
|
|
| |
12 |
|
|
|
55 |
|
|
|
11 | 3 76 |
|
|
108 |
|
| |
Large |
|
| |
| Barrel |
|
|
| 85 |
|
|
11 | 3 |
|
|
|
|
| |
13.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 23 and 24). To protect the floor or carpet from damage, place a mat under the treadmill.
10
