Locate the Reed Switch (22) and the Magnet (18) on |
| Top |
|
the left side of the Pulley (17). Turn the Pulley until the |
|
| |
Magnet is aligned with the Reed Switch. Make sure |
| View |
|
that the gap between the Magnet and the Reed |
|
| 17 |
Switch is about 1/8 in. (3 mm). If necessary, move the |
| 22 | |
Reed Switch slightly using a slotted screwdriver. Next, |
| 18 | |
reattach the Motor Hood (not shown), making sure that |
| 1/8 in. |
|
the #8 x 3/4" Screws (not shown) are in the same holes |
|
|
|
from which they were removed. Then, run the treadmill |
|
|
|
for a few minutes to check for a correct speed reading. |
|
|
|
PROBLEM: The console displays remain lit when you remove the key from the console |
| ||
SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a | |||
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off | |||
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE | |||
INFORMATION MODE on page 20 to turn off the demo mode. |
| ||
PROBLEM: The incline of the treadmill does not change correctly |
|
|
|
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- | |||
move the key. After a few seconds, | |||
maximum incline level and then return to the minimum level. This will recalibrate the incline system. | |||
PROBLEM: The walking belt slows when walked on |
|
|
|
SOLUTION: a. Use only a | |||
b. If the walking belt is overtightened, treadmill perfor- | b |
| |
mance may decrease and the walking belt may be- |
| ||
come damaged. Remove the key and UNPLUG THE |
|
|
|
POWER CORD. Using the hex key, turn both rear |
|
|
|
roller bolts counterclockwise, 1/4 of a turn. When the |
|
|
|
walking belt is properly tightened, you should be able |
|
|
|
to lift each edge of the walking belt 3 to 4 in. (8 to 10 |
|
|
|
cm) off the walking platform. Be careful to keep the |
|
|
|
walking belt centered. Then, plug in the power cord, in- | Rear Roller Bolts |
| |
sert the key, and run the treadmill for a few minutes. |
| ||
Repeat until the walking belt is properly tightened. |
|
|
|
c. If the walking belt still slows when walked on, see the front cover of this manual. |
| ||
23
