21.Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 7, and HOW TO FOLD AND MOVE THE TREADMILL on page 27.) You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.
22.Do not change the incline of the treadmill by placing objects under the treadmill.
23.When folding or moving the treadmill, make sure that the frame is held securely in the storage position.
24.Inspect and properly tighten all parts of the treadmill regularly.
25.Never insert or drop any object into any opening on the treadmill.
26.DANGER: Always unplug the power cord immediately after use, before cleaning the treadmill, and before performing the main- tenance and adjustment procedures de- scribed in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only.
27.The treadmill is intended for
28.If an outside antenna or cable system is con- nected, be sure that the antenna or cable sys- tem is grounded to provide some protection against voltage surges and
29.An outside antenna system should not be lo- cated in the vicinity of overhead power lines
or other electric light or power circuits, or where it can fall into such power lines or cir- cuits. When installing an outside antenna sys- tem, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal.
30.To reduce the risk of electric shock, do not re- move the cover or the back of the television. There are no user serviceable parts inside. Refer servicing to qualified service personnel.
31.To protect the treadmill and TV during light- ning storms, unplug the power cord from the wall outlet and disconnect the antenna or the cable system. This will prevent damage due to lightning and power line surges.
32.Upon completion of any service or repairs to the treadmill or the television, ask the service technician to perform safety checks to con- firm that the unit is in proper operating con- dition.
•Use No. 10 AWG (5.3mm2) copper, No. 8 AWG (8.4mm2) aluminum, No. 17 AWG (1.0mm2)
•Secure an antenna
•Mount an antenna discharge unit as close as possible to where the
•Use a jumper wire not smaller than No. 6 AWG (13.3mm2) copper, or the equivalent when a separate
Note to CATV system installer: This reminder is provided to call the CATV system installer’s at- tention to Article
SAVE THESE INSTRUCTIONS
4