8. Remove the band securing the Upright Wire | 8 |
Harness (73) to the right Upright (85). Have a second person hold the console assembly near the right Upright.
Connect the Upright Wire Harness (73) to the wire harness on the console assembly. See the inset drawing. The connectors should slide to- gether easily and snap into place. If they do not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAM- AGED WHEN THE POWER IS TURNED ON. Then, insert the connectors into the right Upright (85).
Console
Assembly 
73
85 
73
9. Remove the band securing the TV Cable (112) to | 9 |
the left Upright (85). Connect the TV Cable to the cable extending from the console assembly. Then, insert the TV Cable into the left Upright.
Next, insert the brackets on the Handrails (70) into the left Upright (85) and the right Upright (not shown). Make sure that no wires are
Bracket |
pinched.
Console
70
Assembly 
112
85
10. Attach the console assembly to the Uprights
(85) with four Console Bolts (72) and four 3/8" 10 Star Washers (67) (only one side is shown).
Start all four Console Bolts and then tighten them.
85 | 72 |
|
67 | Console | |
| Assembly |
10
