Reebok Fitness RCTL09707.0 manual Sleeve to make sure it is locked into place

5. Identify the Latch Assembly (76). Make sure that
	5
the sleeve has been slid over hole 1 and that the
latch knob is locked into hole 1. Pull on the
sleeve to make sure it is locked into place.
Next, make sure that the latch knob is locked
into hole 2. If it is not, pull out the tube until you
see hole 2 and then slide the tube back in until
the latch knob locks into hole 2.

Hole 2

Latch Knob

	Hole 1
Tube

Sleeve

76

6.Raise the Frame (55) to the position shown. Have a second person hold the Frame until this step is completed.

Remove the plastic ties from the ends of the Latch Assembly (76). Orient the Latch Assembly so that the large barrel and the knob are in the positions shown; make sure that all the holes are aligned as shown in the inset drawings. Attach the lower end of the Latch Assembly to the bracket in the center of the Uprights (85) with a Latch Bolt (109) and a Nut (20).

Attach the upper end of the Latch Assembly (76) to the bracket on the Frame (55) with a Latch Bolt (109) and a Nut (20). Note: It may be neces- sary to move the Frame back and forth to align the Latch Assembly with the bracket.

Lower the Frame (55) (see HOW TO LOWER THE TREADMILL FOR USE on page 28).

7.Identify the Left Base Cover (88), which has cutouts in the locations shown. Slide the Left Base Cover onto the left Upright (85). Then, slide the Right Base Cover (86) onto the right Upright.

Identify the Left Upright Sleeve (77) and the Right Upright Sleeve (9). Slide the Upright Sleeves onto the Uprights (85) as shown.

6

					55
			20										Top
							109
																Holes
										76
		Knob
										Large
										Barrel
											85				Holes
				20									Bottom
									109
7						85
												Left		Right
								77
	Cutouts					88									9

85 86

9