any carbon dust that formed as a result of shipping. It will also remove any air bubbles present in the carbon. Failure to complete this step may result in water not flowing through the mineral dispenser. If carbon dust appears in your reservoir after your first cycle, discard (water is safe to use for plant watering).
Your AquaVié™ Healthy Water System unit is now ready for use.
NOTE: For healthier, great tasting water, replace your mineral dispenser after producing 20 gallons of AquaVié™ water
INSTRUCTIONS FOR PRODUCING AquaVié™ WATER
1.Place your AquaVié™ unit on a dry, level surface in a well ventilated area.Plug the cord into a properly grounded rated voltage AC electrical outlet ONLY.
NOTE: Be sure to place the AquaVié™ unit in a location that provides adequate ventilation during operation, with at least 4 inches (10 cm) of clearance to the sides and back, and 3 inches (8 cm) to the top of the unit. Do not operate the AquaVié™ unit in an enclosed area such as a cupboard or cabinet. The unit must be operated in air temperatures of
2.Remove the boiling chamber from the unit by grasping its handle and pulling it straight out of the AquaVié™ chassis. Do not lift up when pulling the boiling chamber out of the chassis.
CAUTION: To prevent personal injury, burn and/or scald injury, do not remove the boiling chamber until it has cooled completely.
3.Remove the boiling chamber’s cap by turning it counterclockwise. Note the four tabs at the base of the boiling chamber’s fill opening.
4.Fill the boiling chamber with cold tap water to the bottom of the four tabs which equals 1 gallon (4 liters).
Do not overfill the boiling chamber.
5.Replace the boiling chamber’s cap by turning it clockwise.
6.Make sure the baffle is in place and its securing nut is tightened. To do this, insert the long end of the
Start Button
Boiling | Tabs |
| |
Chamber Cap |
|
| Baffle |
| Water |
| Fill |
| Level |
