Regal Ware W15120 manual Press the “start” button at the base of the boiling chamber

baffle, flat side down into the spout and secure with the nut. The hole on the flat side of the baffle should be facing down. It is important that you tighten the securing nut, with baffle properly in place, onto the boiling chamber before each use. Failure to properly secure the baffle and nut may result in leakage or early shut off of the AquaVié™ unit.

7.Wipe off any water on the outside and bottom of the boiling chamber and around the electrical connection.

Flat		O-Ring
Gasket
	Flat edge	Baffle
	of baffle
Spout		Securing
		Nut

8.Slide the boiling chamber into the chassis and press firmly to ensure that it is properly placed. It is important that the boiling chamber be pressed firmly into the chassis. It is recommended that you place one hand on the back of the chassis and push the boiling chamber into the chassis with the other hand. To ensure that a tight electrical connection is made, also press on the base of the boiling chamber near the start button.

Start Button

CAUTION: To prevent personal injury or property damage the boiling chamber must be fully engaged prior to start-up.

9.Press the “start” button at the base of the boiling chamber.

NOTE: The button will glow when the boiling chamber is heating; however, the light will go out, and the boiling chamber will stop heating if electrical power to the boiling chamber is interrupted or stopped. If this occurs, press the start button again to restart the cycle.

Mineral Dispenser

Dispensing

Valve

10.The cooling fan will not start immediately. A delayed fan startup feature has been included in your AquaVié™ system. The fan will start once the boiling chamber has reached a pre-determined temperature, approximately 30-40 minutes after starting the cycle.

-5-