Eddie Bauer 3-In-1, Luxe Trouble Shooting, Off of headrest, Off the shell. Slip off, Armrest pads

4358-3340D Elite_Lux 3/13/06 3:08 PM Page 51

3	Pull pad off the top of seat
	and off of headrest.

4	Pull pad out from under
	buckle cover and work it
	off the shell. Slip off
	armrest pads.

Trouble Shooting

✔1. If your child restraint is not held securely by the belt:

Press down firmly on the child restraint and remove all the slack in the belt. Make sure the belt buckle is not up against the child restraint where the belt cannot be tightened.

Review Locking Clip section and Top Anchorage Strap Section. If you cannot secure the child restraint tightly, move it to another seating location.

✔2. If the child restraint buckle or harness adjustment lever sticks or you cannot get the straps tight enough around child:

DO NOT LUBRICATE. Check around lever and retractor for dropped food, sticky spilled drinks, dirt, leaves, etc. Clean with warm water and/or remove object with tweezers. If you cannot get the harness to adjust and remain tight with the buckle securely locked, do not use the child restraint.

✔3. If your harness twists or ropes: Straighten the harness each time you put your child in the seat to help prevent twisting. Lock the buckle and tighten harness and it will be ready for next use.

5

From the back, use a screwdriver to press in on lip of upper harness guides and pop guides through the front. Pull cover off headrest.

Clean with warm sudsy water, rinse clean and air dry. Do not use bleach or use other harsh cleaners.

✔4. If your infant sits too upright in the rear-facing

position: If your vehicle seat slopes so much that your

	infant is sitting upright, you may
LEVEL	place a rolled towel under the
TO GROUND
	front of the child restraint so
	that the level line on the
	shoulder belt positioning guide is
	level (horizontal). Check often to
	be sure padding is still in place
	and the vehicle belt is tight.

Replace seat pad by reversing order; put pad on headrest and replace upper harness guides. Starting from bottom of child restraint, slip pad on shell; tuck in pad around harness adjuster and over upper belt guides. Make sure pad is under headrest and replace lower harness guides. Rethread harness (see belt-positioning booster section).

!WARNING

Using padding that tilts the base of the child restraint farther back than the level-to- ground line can result in serious injury or death.

48 49