Eddie Bauer 4358-3340D Rear-Facing Installation with Latch Install Latch Belt, Shown installed

4358-3340D Elite_Lux 3/13/06 3:08 PM Page 29

4	Push down firmly on the
	child restraint and pull up
	on belt to tighten. For a
	manual belt, refer to
	“Knowing your Vehicle
	Belt” section. Pull up on
	shoulder strap to remove
	any slack.

NOTE: In some cases, you may need to pull the pad off the front corner and expose the belt path. Tighten belt through belt path slot. Replace pad on corner.

Rear-Facing Installation with LATCH: Install LATCH Belt

1	Do not use the LATCH
	system along with the
	adult lap or lap/shoulder
	belt.
	To thread LATCH belts:
	Pull the seat pad off the
	front corners of shell.

Rear Facing Use: 5-35 lbs. (2.3-16 kg), 19-

5

NOTE: Locking clip is

shown installed.

Locking Clip” sections.

With weakest hand at belt path, tilt and push the child restraint forward and back, and from side to side. If the seat belts do not loosen, your child restraint should be secure.

NOTE: Some “play” from front to back or about an inch from side to side is acceptable. If it moves more, review “Knowing your Vehicle Belts” and “The

2

3

LATCH adjuster can be on either side, but belt should not be twisted.

Route entire LATCH belt through the upper slot in side of shell.

Reach under pad, pull one

36” (48-91 cm).

After checking for hot seat and buckles, secure child as described in “Securing Your Child in the Child Restraint” section.

!WARNING

Using the child restraint in any vehicle seat where the lap belt cannot be tightened securely and properly or where it can be loosened by pulling on it can result in serious injury or death.

LATCH hook between rear harness slot and buckle strap.

26 27 continued on next page.