4358-3340D Elite_Lux

3/13/06

4

 

3:08 PM Page 37

With weakest hand at the belt path, tilt and push the child restraint from side to side. If the LATCH

Forward-Facing Installation with LATCH Belt: Install LATCH Belts

Forward-

NOTE: Locking clip is shown installed.

belts do not loosen, your child restraint should be secure.

NOTE: Some “play” from front to back or about an inch from side to side is acceptable. If it moves more, review “Knowing Your Vehicle Belts” and “The Locking Clip” sections.

1

NOTE: Do not use LATCH system along with the adult lap or lap/shoulder belt.

Route LATCH belt through upper slot in side of shell.

Facing Use: 22-40 lbs. (10.1-18

!WARNING

Using this child restraint in any vehicle seat where the lap belt cannot be tightened securely and properly or where it can be loosened by pulling on it can result in serious injury or death.

2

Pull one LATCH hook across the back and out the other side.

The LATCH adjuster can be on either side, but the belt should not be twisted.

kg), 34-43” (85.1-110 cm),

5

After checking for hot

seat and buckles, place

 

your child in the child

 

restraint as described in

 

the “Securing Your Child in

 

the Child Restraint”

 

section.

3

Connect and tighten

 

harness straps prior to

 

installing in vehicle.

Place child restraint flush against the back of the vehicle seat forward- facing in the back seat.

The recline position is to be used only to install the child restraint flush against the back of the vehicle seat back, if needed.

Over 1 year of age.

34

35

continued on next page.

Page 19
Image 19
Eddie Bauer 4358-3340D, Luxe, Elite, 3-In-1 manual Your child in the child, Restraint as described, Over 1 year of age