4 | Push LATCH hook |
through the | |
| belt path slot. |
Rear-Facing Installation with LATCH: Install in Vehicle
Rear Facing
Pull other end of LATCH hook under pad in front of crotch strap to the opposite side.
1 | LEVEL | Connect and tighten |
TO GROUND | harness straps prior to | |
| ||
|
| installing in vehicle. |
|
| Place child restraint rear- |
|
| facing in the back seat. With |
|
| child restraint in the most |
|
| reclined position, make sure |
|
| level lines on shoulder belt |
|
| positioning guide are level |
with ground. Adjust child restraint if needed. | ||
NOTE: Tuck top anchorage strap and hook under the base or child restraint.
Use:
Do not place LATCH belt over child’s legs.
2 |
Fasten one LATCH belt hook to the anchor in the vehicle seat located in the vehicle seat bight. Repeat for other side of child restraint. See your vehicle
6 |
Push LATCH hook through the other rear- facing belt path slot.
3 |
owner’s manual for more information.
Push down firmly on the child restraint and pull up on the loop to tighten belt.
7 |
Put seat pad back over corners of shell.
Completed threading of the LATCH system rear- facing is shown.
NOTE: In some cases, you may need to pull the pad off the front corner and expose the belt path. Tighten belt through belt path slot. Replace pad on corner.
28 | 29 | continued on next page. |
