Regency P131-NG Log Installation, Push back side of the left end of the log up, 326, Grate Post

INSTALLATION

LOG INSTALLATION

Read the instructions below carefully and refer to the dia- grams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

Log Kit # 360-930 contains the following pieces:

a)	326	Front Right Log	902-326
b)	327	Front Left Log	902-327
c)	328	Middle Right Log	902-328
d)	329	Middle Left Log	902-329
e)		Embers	902-154

Please note that there are 2 of each log. This log set is mirrored front and back.

327

326

329328

The 3-digit numbers (ie. 327) are molded into the rear of each log.

The image below shows all of the logs in place.

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Place Log 326 on the front right side of the burner. Ensure that the notches on the far right side of the log fit into the grate posts. Push back side of the left end of the log up against the tab on the burner.

326

Push back side of the left end of the log up

against the tab on the burner.

Repeat step 2 on the opposite side of the burner.

326

326

328 326 329 327

3)Place Log 327 on the front left side of the burner. Position the right end of the log in between the two tabs and the left end of the log into the grate post.

327 329 326 328

327

Grate Post

Tab on Burner

24 Regency P121/P121LC/P121RC/P131 Zero Clearance Room Sealed Gas Fireplace