INSTALLATION
GLASS DOOR
REMOVAL
FINISHING TRIM | LOUVERS & GRILLS |
1)Remove the 8 screws that secure the glass door.
2)Pull the door slightly out on an angle and then lift up and pull completely out.
1)Slide the Side Finishing Trim up into the slot in the top flange of the fireplace. Push tight against the magnet at the base of the unit.
Slide Trim into
slot.
Push trim tight against magnet.
2)Slide the Corner Finishing Trim up into the slot in the top flange of the fireplace. Push tight against the magnet at the base of the unit.
1)Attach the screws provided to the top left and right corners.
NOTE: Do not tighten the screw entirely, ensure that some room is left to be able to hang the grill or louver over the screw.
2)Hang the Top Louver or Grill onto the 2 screws in the top fireplace opening.
3)Attach the Bottom Louver or Grill to the hinges on the bottom flange of the fireplace.
3)P131 & P121LC/P121RC Corner Model: Remove the 6 screws that secure the glass door and repeat step 2.
Slide Trim into
slot.
Push trim tight against magnet.
P121 & P131 Corner Models
4)Attach the screws provided to the top and bottom, left and right corners similar to step 1.
5)Hang the top and bottom louver or grill onto the screws in the top and bottom, left and right sides of the fireplace opening.
The Top and Bottom Side Louver or Grill is
installed the same way.
26 | Regency P121/P121LC/P121RC/P131 Zero Clearance Room Sealed Gas Fireplace |
