Regency Wraps Z2510L Installation, Finishing Details, Completing the Mantle, Top View Top View

INSTALLATION

4)Place side metal filler strips in between stove and framing to cover the stand-off space. Fit the strips behind "A" so that they cover the stand-offs, and will prevent mor- tar from falling through the mesh.

5)Center door arch edge, mark and drill holes. Note the top of the side pieces meet up with the edges of the center arch. Attach arch edge and bottom of grill edge to unit. The door arch floats at each end so that it can be adjusted to match the curve of the door.

6)Depending on the height of the hearth in front of the unit, it may be necessary to trim the bottom of the mesh sides (B) to fit. Mark and drill holes for side pieces. Attach with washers and screws.

7)Place the top metal filler strip in between stove and framing to cover the stand-off space. Fit the strips behind Top mesh "C" so that it covers the stand-off, and will prevent mortar from falling through the mesh.

8)Put the door on the unit and check that the veneer on the door hinge side does not interfere with the door swing.

9)Use washers and screw top mesh (C) to top of grill frame. This is attached with the top edge of the grill frame on piece (B).

10)Now fasten mesh to wall sheathing and blend in.

11)Use only non-combustiblemasonry products to finish fireplace front.

Finishing Details

Consideration must be given to fireplace place- ment when deciding on how to complete the facing.

IMPORTANT: A tight joint between masonry and fireplace is necessary to prevent heat from rolling up the front to the Face Header.

Example 1:

Face of Fireplace Flush with Wall Framing.

Example 2:

Face of Fireplace Flush with Wall Sheathing.

Top View

Top View

Completing the Mantle

A stone mantle may be placed directly above or below the warm air outlet. If a wood or other combustible mantle is desired, it must be at least 18 inches above the grill opening and may project up to 10 inches in front.

Top View

18 Regency Z2510 WarmHearth