REL Acoustics Strata 5, Stampede user manual GROUND see below

REL Acoustics ST 5 User Manual

To connect to MONO BLOCK power amplifiers using the High Level Neutrik UNBALANCED input

To engage the Neutrik Speakon plug, insert fully into socket and rotate clockwise until locked.

To remove the Neutrik Speakon plug, grip body of plug, place thumb on chrome lever, move lever backwards rotate the plug anti-clockwise (counter-clockwise in the US) a quarter turn and withdraw.

	Supplied Neutrik Speakon High level Interconnect
						RED
HI LEVEL input	Release lever	YELLOW	+	-	+	-
				L		R
			MONO		MONO
	BLACK		BLOCK		BLOCK
			SPK OUT		SPK OUT
	PRE AMPLIFIER
	GROUND (see below)

High Level connections should be made to the same binding posts as the main speakers

Using a single sub-bass system, connect as shown above. Connect RED to right monoblock speaker positive (red) terminal, connect YELLOW to left monoblock speaker positive (red) terminal. The BLACK should be connected to ground at the pre amplifier. If the pre amplifier does not have a dedicated ground terminal, then use one of the chassis screws at the rear of the pre amplifier.

NOTE: MAKE SURE THAT ANY CHASSIS SCREW THAT IS CHOSEN IS NOT CAPTURED ON THE INSIDE WITH A NUT AS THE NUT COULD DROP INSIDE THE UNIT.

The output level can be adjusted by using one of the two methods described in the last section.

12