REL Acoustics Strata 5 Display of Memory Function, Control Panel, Factory Default Settings

REL Acoustics ST 5 User Manual

Display of Memory Function

1st. memory position store. Press MEMORY the display will show Pr – (Profile)

Press LFE + button, the display will show Pr –1 and the settings will be stored.

1st. memory position recall. Press MEMORY the display will show Pr – (Profile)

Press LFE - button, the display will show Pr 1 and the settings will be recalled.

Repeat the above procedure for memory positions 2,3 and 4 using the HIGH LEVEL, FREQUENCY and SLAM/DEPTH + and – buttons.

For memory position 2 display will show Pr –2 to store and Pr 2 to recall For memory position 3 display will show Pr –3 to store and Pr 3 to recall For memory position 4 display will show Pr –4 to store and Pr 4 to recall

CONTROL PANEL

DISPLAYENCODER

All the functions shown on page 9 and 10 are available via the remote control and the encoder on the front control panel.

When using the front control panel, the functions are accessed by sequential presses of the control knob, the function being displayed on the two left hand digits of the seven-segment display. When the required function is accessed, the value can be adjusted by rotating the control knob, the value being displayed on the two right hand digits of the seven-segment display.

FACTORY DEFAULT SETTINGS

Before the MEMORY positions are programmed with the user’s preferences they are all pre programmed with factory defaults as follows:-

LFE	30
HIGH LEVEL	30
FREQUENCY	30
SLAM/DEPTH	0
LFE MUTE	Off
PHASE	0
DISPLAY TIMEOUT	Off
DISPLAY BRIGHTNESS	Max (10)
DC TRIGGER	Hi

To reset factory defaults, switch off the unit by means of the rear mains ON/OFF switch. Then switch back ON as you hold in the encoder knob on the control panel, continue to hold the knob in until the decimal point on the right hand digit appears. You will now have reset to the original factory defaults.

8