REL Acoustics Stampede, Strata 5 user manual

REL Acoustics ST 5 User Manual

To connect to the amplifier/processor/receiver using the phono to phono LFE interconnect

Alternative method for connecting at Low Level from pre amplifier

In some circumstances it is not possible to use the high level method of connection, for example when using active speakers. Instead of using the attenuator as shown on page 15, connect as shown below using a “Y” adapter from the left and right pre amplifier outputs and a single phono to phono interconnect from the “Y” adapter to one of the low level inputs on the

REL. Phono to Phono Interconnect.

To sub/LFE output of

Only use this method if the pre amplifier has two separate outputsAmplifier/Processor. Sub LFE

Inputthe unlikely event that the second pre amplifier output is only a parallel connection to the other then this method will cause a mono signal to be sent to the main amplifier(s) or active speakers.

Connect as shown above using a phono to phono interconnect. Plug one end into the sub/LFE output on the amplifier/processor and the other end into the LFE LEVEL input on the sub-bass system.

The output level can be adjusted by one of two methods.

1.By using the remote control: press the buttons marked LFE LEVEL ‘+’ or ‘-‘. The front control panel will show ‘Hi’ on the two left hand digits. The volume level can be adjusted up or down by pressing the ‘+’ or ‘-‘ buttons and the display will show 00 to 99 on the two right hand digits.

2.By using the encoder control on the front control panel: press the control knob to select ‘LF’ on the two left hand digits, rotate control knob to select the value in the range 00 to 99 on the two right hand digits.

13