12
6 troubleshooting
WARNING: Unplug blower/vac from power source before servicing. Severe injury or death could occur from fire, electrical shock, or rotating impeller.
Note: For additional help, visit our technical ser vice web site at www.desatech.com.
OBSERVED FAULT | POSSIBLE CAUSE | REMEDY | ||
Motordoesnotrunwhenyouturnon/off | 1. | Bottom inlet cover or vacuum tube | 1. | Check inlet cover or vacuum tube |
switch low or high |
| adapter not locked into place |
| adapter for proper installation (see |
|
|
|
| blower/vac assembly, page 4) |
| 2. | Extension cord connection is loose | 2. | Check cord connection at electrical |
|
|
|
| outlet and at rear of blower/vac |
Motor runs, but vacuum will not pick | 1. | Clogged vacuum tube or impeller | 1. | Follow steps under Removing |
up debris |
|
|
| Clogged Debris from the Impeller, |
|
|
|
| page 10 |
| 2. | Vacuum bag full | 2. | Empty vacuum bag (see Emptying |
|
|
|
| the Vacuum Bag, page 10 |
Blower/vac vibrates excessively and/or | Clogged vacuum tube or impeller | Follow steps under Removing Clogged | ||
makes abnormal noises |
|
| Debris from the Impeller, page 10 |
Technical Service
You may have further questions about assembling,operating,or maintaining this blower/vac.If so,you can visit ourTechnical Service web site at www.desatech.com or contact ourTechnical Service Department at
DESA Specialty Products™
ATTN: Technical Service Specialty Products
P.O. Box 90004
Bowling Green, KY
When contacting DESA Specialty Prod- ucts™, have ready
•Your Name
•Your Address
•Your Phone Number
•Model Number of Product
•Date of Purchase (include copy of receipt for written requests)
118034