OPERATING CHAIN SAW

Continued

BUCKING A LOG

WARNING:Avoid kickback.Kickback can result in severe injury or death. See Kickback, pages 4 and 5, to avoid risk of kickback.

WARNING:

If on slope, make sure log will not roll down hill. Secure log by using wooden stakes. Drive wooden stakes into ground on downhill side of log. Stand on uphill side of log while cutting. Log may roll after cutting.

Never try cutting through two logs at same time.This could increase the risk of kickback.

While cutting log, never hold log with your hand, leg, or foot.

While cutting log, never allow another person to hold log.

Turn off and unplug saw before moving from one place to another.

Bucking a log is cutting a log into sections. Make sure your footing is firm. Keep feet apart. Divide your weight evenly on both feet. When possible, raise log or section off ground. Do this by using limbs, logs, chocks, etc.

When cutting through log, maintain control by reduc- ing cutting pressure near end of cut. Do not relax your grip on chain saw handles. Do not let moving chain touch ground. Ground will dull moving chain. After cutting through log, release trigger to turn saw off before moving saw.

Follow directions below to buck a log.

Entire Length Of Log On Ground

Cut log from top (see Figure 16).

Figure 16 - Bucking Log With Entire Length On Ground

Log Supported On One End

1.

Make first cut on underside of log (see Figure

 

 

17). Use top of guide bar to make this cut. Cut

 

 

1/3 through diameter of log. This cut will keep

 

 

section from splintering when cut.

 

2.

Make second cut directly above first cut. Cut

 

 

down to meet first cut. This cut will keep log

ENGLISH

 

from pinching guide bar and chain.

 

 

Log Supported On Both Ends

 

1.

Make first cut from above log (see Figure 18).

 

 

Cut 1/3 through diameter of log. This cut will

 

 

keep section from splintering when cut.

 

2.

Make second cut on underside of log, directly

 

 

under first cut. Use top of guide bar to make this

 

cut. Cut up to meet first cut. This will keep log from pinching guide bar and chain.

TRIMMING A TREE (Pruning)

WARNING:Avoid kickback.Kickback can result in severe injury or death. See Kickback, pages 4 and 5, to avoid risk of kickback.

2nd Cut

1st Cut

Figure 17 - Bucking LogWhen Log Is Supported On One End

1st Cut

2nd Cut

Figure 18 - Bucking LogWhen Log Is Supported On Both Ends

Continued

113005

13

www.desatech.com

Page 13
Image 13
Remington M12510US, M15012US, M15014US, M15014AS, M30016US, M30016AS, M30016AW, M35016UW, M35016AW Bucking a LOG