Remington MS2-300, MS2-400 Cleaning your shaver, Trimmer Care, Replacing Screens and Cutters

Cleaning your shaver:

TO ASSURE SMOOTH, EFFICIENT PERFORMANCE,IT IS IMPORTANT TO CLEAN YOUR SHAVER. Cleaning your Remington® MicroScreen® 2 Shaver is easy.

■After each shave, remove the shaver head by squeez- ing on both release buttons and pulling up from the body of the shaver. Blow out the stubble thoroughly.

Important: Never clean the foil with the enclosed brush because damage may occur to the holes in the foil.

■At least once a week, the cutters and the trimmer should be cleaned with the cleaning brush.

Attention: Never put the shaver in part or completely into water. Do not

use an aggressive cleansing agent as this may destroy the shaver coatings.

■Daily cleaning of the cutting system is recommended to ensure optimum shaving performance. To clean and lubricate your shaver's cutters and head assembly, apply Remington® Shaver Saver® Lubricant (SP-4).The lubri- cant helps remove hair clippings while reducing wear. A quick spray after each shave keeps your shaver operat- ing at peak performance.

Caution: Do not remove or replace the head assembly while shaver is running as it may cause damage to the unit's foils or cutters.

■Worn or damaged parts should be replaced with Remington® replacement parts only.

Trimmer Care

®	®	®
The trimmer on your Remington	MicroScreen	2 TCT Shaver is
easy to maintain.

■To clean the trimmer, you must first turn the shaver off, and extend the trimmer to its maximum height (trimmer setting #3). Then, just brush off any clippings that may accumulate around the trimmer assembly. Using the brush supplied will enable you to get into the area between the trimmer and the shaver.

■Every six months lubricate the trimmer by applying a drop of light machine oil one-third and two-thirds of the way along the blade. Using your fingertip, spread the oil along the teeth, and run the trimmer for a few seconds.

Replacing Screens and Cutters

Because they are subject to daily use, the cutters and foils of your

®	®	®
Remington MicroScreen	2 TCT	Shaver will wear and eventually
require replacement to maintain a close, comfortable shave.
Depending on your shaving technique and habits, the foils will

usually last six months; the cutters, one year. Some signs that your foils and cutters need replacing are:

■Irritation. As foils get worn, you may notice that your skin feels more sensitive after a shave, particularly when you apply aftershave.

■Pulling. As cutters wear, your shave may not feel as close and you may feel your shaver is pulling at your whiskers.

■Wear-through. You may notice that the cutters have worn through the foil.

To prevent inadvertent damage to the Screen and Cutter Assembly, do not attempt to remove them unless you are replacing them. To remove the old screens and cutters follow the instructions that come with the screen and cutter replacement package. It’s always a good idea to replace the screens when you replace the cutters.

To Replace a Cutter Assembly That is

Removed Unintentionally:

■Hold the assembly in the middle of the "T".

■Gently slide the plastic portion of the cutter assembly over the top of the oscillator tip.

■Do not push downward on the ends of the cut- ters,as you may bend the cutter, reducing its ability to operate smoothly.

■Do not remove cutters from the plastic pieces to which they are attached, as you may damage the assembly.