Remington PG-300 Troubleshooting, You need help Service information or locations

G03-041 pg-300 web ib 9/1/05 9:45 AM Page 4

Cleaning & Maintenance con’t

The MiniScreen shaver should be cleaned as follows:

■Press the buttons at ends of screen head.

■Remove head and shake out clippings.

■Blow/brush off cutter.

■Replace head–make sure that it snaps in place.

■DO NOT RINSE or OIL MINISCREEN SHAVER. The unit has been lubricated at the factory.

Troubleshooting

The groomer does not work when turned on:

■Groomer must be charged for a full 14-16 hours.

■Contact an authorized Remington Service Center regarding battery replacement.

Groomer cutters do not move:

■The cutting unit may be dirty and clogged. Clean and lubricate the unit as directed in the Cleaning

& Maintenance section.

Groomer does not hold charge:

■Fully discharge battery by running groomer until it stops; then follow recharging instructions (see section on Charging/Recharging). If time between recharging cycles does not increase, battery may need replacing.

Contact an authorized Remington Service Center.

You need help,

service information or locations:

Call 800-736-4648for the authorized Remington Service Center closest to you in the U.S. or 888 277-6333 in Canada.

Product Features

PG-300

This side for trimming neckline & sideburns

Hair length attachment 1

Hair length attachment 2

MiniScreen shaver attachment

This side for trimming

Nose, ear, eyebrow

On/Off switch

Groomer