Renesas M32100T-EZ-E 2.4 Name of Each Part

( 17 / 42 )

Name ON/OFF

OFF

ON

OFF

Meaning

Emulator system is turned off.

Emulator system is turned on.

Emulator system is not operating normally.

1.Emulator hardware is being configured. This occurs after the emulator

is powered on until the emulator debugger gets started.

2.Emulator is in special mode (maintenance mode) for downloading

firmware. Only firmware download is executed.

Emulator system is operating normally.

Emulator is operating normally.

Firmware is being downloaded.

1.Emulator is not operating normally.

2.Emulator is in special mode (maintenance mode) for downloading

firmware. Only firmware download is executed.

Blinking

ON

OFF

Blinking

POWER

SAFE

ERROR

2.4 Name of Each Part

Here explains the name and function of each part.

(1) Names and Functions of Parts on the Upper Panel

Figure 2.2 Name of each part on the upper panel

1. System status LEDs

The system status LEDs indicate the M32100T-EZ-E emulator's power supply, firmware

operating status, etc. Table 2.1 lists the definitions of the system status LEDs.

Table 2.1 Definitions of the system status LEDs

Target status LEDs

System status LEDs

Emulator M32100T-EZ-E

ON

Contents

Main ( 2 / 42 ) Preface To use the product properly Precautions for Safety Contents Page Chapter 1. Precautions for Safety WARNING IMPORTANT CAUTION WARNING CAUTION Notes on Product Information: Notes on Downloading Firmware: Notes on USB Interface: Notes on Dependencies on the MCU Model: Note on Stack Capacity and Stack Pointer: Page Notes on Target System: Page Page Chapter 2. Preparation 2.1 Terminology 2.2 Package Components 2.3 System Configuration of the M32100T-EZ-E (1) JTAG Connection 2.4 Name of Each Part Here explains the name and function of each part. (1) Names and Functions of Parts on the Upper Panel Page (2) Names and Functions of Parts on the Side Panel (3) Names and Functions of Parts on the Front Panel (4) Names and Functions of Parts on the Rear Panel Page Chapter 3. Setup 3.1 Connecting the Host Machine 3.2 Connecting the Target System (1) Connecting the SDI Interface Connector Figure 3.3 Connecting the SDI interface cable (2) SDI MCU Control Interface Connector Page (3) Emulator Side Circuit Diagram Page Page Chapter 4. Usage 4.1 Turning on the Power Supply (1) Checking the Connections of the System (2) Turning On/Off the Power Supply Notes on Power Supply to the Target Board: Note on Downloading Firmware: Page Page ( 32 / 42 ) Chapter 5. Specifications 5.1 Specifications Table 5.1 lists specifications of the M32100T-EZ-E. Table 5.1 Specifications of the M32100T-EZ-E Page ( 34 / 42 ) Chapter 6. Troubleshooting 6.1 Flowchart to Remedy Troubles Figure 6.1 Flowchart to remedy troubles See the emulator debugger online help. See, "3.2 Connecting the Target System" (page 23). 6.2 When the Emulator Debugger Does Not Start Up Properly (1) When the LED Display of the M32100T-EZ-E is Abnormal See the M32100T-EZ-E User's Manual. See "4.1 Turning on the Power Supply" (page 28). Table 6.1 LED's abnormal display and its checkpoints (2) Errors Occur When the Emulator Debugger Starts Up Table 6.2 Checkpoints of errors when starting up the emulator debugger Page Chapter 7. Maintenance and Guarantee 7.1 Maintenance 7.2 Guarantee 7.3 Repair Provisions CAUTION Note on Transporting the Product: