Renesas M32100T-EZ-E Chapter 3. Setup

( 22 / 42 )

Figure 3.2 USB interface connection procedure

*1 For installation, refer to "Installing the USB Device Driver" of the PD32RM user's

manual (online help).

*2 When the emulator debugger is started up for the first time or when the emulator

debugger has been upgraded, the dialog which prompts for downloading the

firmware will appear. Then, download the firmware following the messages.

Connect the included USB interface cable to the USB interface connector

of the M32100T-EZ-E.

Connect the included USB interface cable to the USB port of the host

machine.

Install the USB device driver*1.

Start up the emulator debugger*2.

Chapter 3. Setup

Figure 3.1 shows how to setup the M32100T-EZ-E.

Install the emulator debugger before setting up the M32100T-EZ-E. For installing the emulator

debugger, refer to the PD32RM release notes.

Figure 3.1 Setup procedure

3.1 Connecting the Host Machine

The emulator is connected to the host machine via the USB interface. Figure 3.2 shows how to connect

the USB interface.

Connect the host machine.

Connect the target board.

* By connecting the USB interface cable, power is supplied to the M32100T-EZ-E.

Contents

Main ( 2 / 42 ) Preface To use the product properly Precautions for Safety Contents Page Chapter 1. Precautions for Safety WARNING IMPORTANT CAUTION WARNING CAUTION Notes on Product Information: Notes on Downloading Firmware: Notes on USB Interface: Notes on Dependencies on the MCU Model: Note on Stack Capacity and Stack Pointer: Page Notes on Target System: Page Page Chapter 2. Preparation 2.1 Terminology 2.2 Package Components 2.3 System Configuration of the M32100T-EZ-E (1) JTAG Connection 2.4 Name of Each Part Here explains the name and function of each part. (1) Names and Functions of Parts on the Upper Panel Page (2) Names and Functions of Parts on the Side Panel (3) Names and Functions of Parts on the Front Panel (4) Names and Functions of Parts on the Rear Panel Page Chapter 3. Setup 3.1 Connecting the Host Machine 3.2 Connecting the Target System (1) Connecting the SDI Interface Connector Figure 3.3 Connecting the SDI interface cable (2) SDI MCU Control Interface Connector Page (3) Emulator Side Circuit Diagram Page Page Chapter 4. Usage 4.1 Turning on the Power Supply (1) Checking the Connections of the System (2) Turning On/Off the Power Supply Notes on Power Supply to the Target Board: Note on Downloading Firmware: Page Page ( 32 / 42 ) Chapter 5. Specifications 5.1 Specifications Table 5.1 lists specifications of the M32100T-EZ-E. Table 5.1 Specifications of the M32100T-EZ-E Page ( 34 / 42 ) Chapter 6. Troubleshooting 6.1 Flowchart to Remedy Troubles Figure 6.1 Flowchart to remedy troubles See the emulator debugger online help. See, "3.2 Connecting the Target System" (page 23). 6.2 When the Emulator Debugger Does Not Start Up Properly (1) When the LED Display of the M32100T-EZ-E is Abnormal See the M32100T-EZ-E User's Manual. See "4.1 Turning on the Power Supply" (page 28). Table 6.1 LED's abnormal display and its checkpoints (2) Errors Occur When the Emulator Debugger Starts Up Table 6.2 Checkpoints of errors when starting up the emulator debugger Page Chapter 7. Maintenance and Guarantee 7.1 Maintenance 7.2 Guarantee 7.3 Repair Provisions CAUTION Note on Transporting the Product: