Renesas M32100T-EZ-E Chapter 4. Usage

( 28 / 42 )

Chapter 4. Usage

4.1 Turning on the Power Supply

(1) Checking the Connections of the System

Before turning on the power, check the connections of the host machine, communications interface

cable, emulator and target system.

(2) Turning On/Off the Power Supply

•When turning on, activate the M32100T-EZ-E first and then the target system.

•When turning off, deactivate the target system first and then the M32100T-EZ-E.

•Always wait for about 10 seconds after turning off the power before turning it on again.

• Power to the emulator is supplied via the USB interface cable.

IMPORTANT

Notes on Power Supply to the Target Board:

•The emulator's pin VCC is connected to the target system in order to monitor target

system voltage. For this reason, the emulator cannot supply power to the target

system. Therefore, provide the target system with a separate power supply.

•Do not change the power supply voltage after the target system has been activated.

Note on Power Supply to the Emulator:

•Power is supplied from the host machine to this product via the USB interface cable.

Take note of the fact that by connecting the USB interface cable, the M32100T-EZ-

E is powered on.

Contents

Main ( 2 / 42 ) Preface To use the product properly Precautions for Safety Contents Page Chapter 1. Precautions for Safety WARNING IMPORTANT CAUTION WARNING CAUTION Notes on Product Information: Notes on Downloading Firmware: Notes on USB Interface: Notes on Dependencies on the MCU Model: Note on Stack Capacity and Stack Pointer: Page Notes on Target System: Page Page Chapter 2. Preparation 2.1 Terminology 2.2 Package Components 2.3 System Configuration of the M32100T-EZ-E (1) JTAG Connection 2.4 Name of Each Part Here explains the name and function of each part. (1) Names and Functions of Parts on the Upper Panel Page (2) Names and Functions of Parts on the Side Panel (3) Names and Functions of Parts on the Front Panel (4) Names and Functions of Parts on the Rear Panel Page Chapter 3. Setup 3.1 Connecting the Host Machine 3.2 Connecting the Target System (1) Connecting the SDI Interface Connector Figure 3.3 Connecting the SDI interface cable (2) SDI MCU Control Interface Connector Page (3) Emulator Side Circuit Diagram Page Page Chapter 4. Usage 4.1 Turning on the Power Supply (1) Checking the Connections of the System (2) Turning On/Off the Power Supply Notes on Power Supply to the Target Board: Note on Downloading Firmware: Page Page ( 32 / 42 ) Chapter 5. Specifications 5.1 Specifications Table 5.1 lists specifications of the M32100T-EZ-E. Table 5.1 Specifications of the M32100T-EZ-E Page ( 34 / 42 ) Chapter 6. Troubleshooting 6.1 Flowchart to Remedy Troubles Figure 6.1 Flowchart to remedy troubles See the emulator debugger online help. See, "3.2 Connecting the Target System" (page 23). 6.2 When the Emulator Debugger Does Not Start Up Properly (1) When the LED Display of the M32100T-EZ-E is Abnormal See the M32100T-EZ-E User's Manual. See "4.1 Turning on the Power Supply" (page 28). Table 6.1 LED's abnormal display and its checkpoints (2) Errors Occur When the Emulator Debugger Starts Up Table 6.2 Checkpoints of errors when starting up the emulator debugger Page Chapter 7. Maintenance and Guarantee 7.1 Maintenance 7.2 Guarantee 7.3 Repair Provisions CAUTION Note on Transporting the Product: