( 31 / 38 )
6. LED of PC4000E

6.1 LED Indication at Emulator Startup

The emulator checks the PC4400 system immediately after startup. During system check the
PC4000E's SAFE LED flashes and the ERROR LED stays on steady. If the SAFE LED does not flash,
it means that the system check program is not operating. In such a case, check whether the PC4000E,
PC4400 card cage and each circuit board are fitted correctly. When the system check is completed,
the emulator status is indicated by the LEDs on the PC4000E.
Table 6.1 shows the LED indications at startup of PC4400.
Table 6.1 LED indication at emulator startup

6.2 LED Indication during Emulator Operation

It is possible to check the emulator status during operation by its LED indicators.
Table 6.2 shows the LED indications during emulator operation.
Table 6.2 LED indications during emulator operation
SAFE
Turned ON
ERROR
Turned OFF
Condition of PC4000E
The emulator has started up properly.
Following may be considered:
•Some board in the PC4400 main unit slot is not fitted in
correctly. Check whether each board is fitted correctly.
•An error is detected by the PC4400's system check. The
PC4400 system may be faulty. Contact your local distributor for
repair.
Flash alternately
LED display
SAFE ERROR Condition of PC4000E
The emulator is ready to execute debug commands of emulator
debugger RTT72.
The evaluation MCU is in the power-down mode or the emulator
system has been reset.
In this case, no debug command of emulator debugger RTT72
can be executed.
In the power-down mode, execute the debug command after
resuming by the key-on wakeup function.
Turned ON Turned ON
Turned ON Turned OFF
LED display