ResMed 60891/1 manual Additional Information, Disposal, Reassembling the Headgear

Note: If the clip does not slide easily, check that the pillow sleeve edge is fitted flush to the groove of the frame.

3Attach the headgear ring to the pillow sleeve assembly. To do this, firmly push the headgear rings onto the ends of the frame (D-3). When attaching the pillow sleeve assembly make sure:

•the headgear panels are facing out

•the nasal pillows are pointing upwards

•the ResMed logo faces out—away from the headgear.

Make sure the pillow sleeve assembly is properly fitted to the headgear before going on to the next step.

4Attach the short tube assembly to your preferred side of the pillow sleeve assembly. To do this, push the elbow into the seal ring until it clicks into place (D-4).

5Insert the cap into the other seal ring until it clicks into place (D-5).

6The assembled system should look like this (D-6). Make sure the ResMed logo on the pillow sleeve faces out—away from the headgear.

Additional Information

Reassembling the Headgear

See section E on the illustrations sheet.

If taken apart, the headgear has four parts:

A: Left strap; B: Right strap; C: Back buckle; D: Top buckle.

1Lay out the four parts of the headgear as shown in (E-1). The panels must face up.

Note: Before threading the straps, make sure that the buckles are positioned as shown in (E-2)and (E-3).

2Thread the back straps through the back buckle (part C) as shown in (E-2a) and (E-2b).

3Thread the top straps through the top buckle (part D) as shown in (E-3a) and (E-3b).

Disposal

The Mirage Swift II Nasal Pillows System does not contain any hazardous substances and may be disposed of with your normal household refuse.

6