ResMed 60891/1 manual Cleaning the Mirage Swift II between Patients, Reassembling the Mirage Swift

Weekly

Handwash the headgear, tube retainer and all components in warm, (approx. 30°C), soapy water. Use pure soap. Rinse the components well and allow them to air dry out of direct sunlight.

. CAUTION

•Do not use solutions containing bleach, chlorine, alcohol, aromatics, moisturizers, antibacterial agents, or scented oils to clean any part of the system or air tubing. These solutions may cause damage and reduce the life of the product.

•Exposing any part of the system or tubing to direct sunlight or heat may cause deterioration.

•If any visible deterioration of a component is apparent (cracking, crazing, tears etc), the component should be discarded and replaced.

Cleaning the Mirage Swift II between Patients

All system components other than the short tube assembly can be disinfected/ sterilized using validated procedures. Clinicians should refer to the Masks Disinfection/Sterilization Guide for details.

The short tube assembly should not be reused. It should be replaced between patients.

To clean the headgear between patients use the method described in the previous section “Cleaning the Mirage Swift II in the Home”.

Reassembling the Mirage Swift II

CAUTION

Components of the Mirage Swift II pillow sleeve assembly (pillow sleeve, frame and clip—see section A on the illustration sheet) are not compatible for use with Mirage Swift components. Combining these components from the two systems may result in rebreathing of exhaled air.

See section D on the illustrations sheet.

1Make sure both seal rings are properly fitted to the headgear rings (D-1).

2 Assemble the pillow sleeve assembly. To do this:

a Wrap the pillow sleeve around the frame. Then insert the pillow sleeve edges into the groove of the frame (D-2a).

b Hold the clip at one end and then slide it onto the frame to secure the pillow sleeve in place (D-2b).

English

5