Wireless Monitor Operation
1.Remove battery access cover (A) on back of monitor and install 2 AA batteries. (Observe correct battery polarity which is embossed in the bottom of the battery compartment). Replace battery access cover.
5.Locate and hold the SYSTEM UPDATE button (C) on the wireless monitor for 5 seconds. All 3 LEDs will flash until the monitor links to the generator. Once it links, the monitor will display the current state. The monitor will try to link for 1 minute. (This step can only be completed when the generator is in Linking Mode).
GENERATOR POWER
SERVICE NEEDED
systemSYSTEM UPDATEupdate
# of flashes | service needed |
1 low battery voltage | 5 low frequency |
2 low fluid level | 6 engine overspeed |
3 under/over voltage | 7 high temperature |
4 engine does not start | 8 transfer switch |
part #: 316197 fcc id: | |
+ | - |
- | + |
GENERATOR READY |
GENERATOR POWER |
A |
DEALER NAME |
DEALER PHONE |
NOTICE The wireless monitor was linked to the generator at the factory. Communication will begin upon the installation of the batteries and the generator being placed in AUTO mode. You may need to press System Update one time
2.The wireless monitor does not have an on/off switch. When batteries are installed correctly, the GENERATOR READY green LED light will flash once every 7 seconds indicating the status of the generator.
NOTICE If communication does not begin upon placing the generator in AUTO, installing batteries, and pressing System Update, the monitor may need to be
3.Locate the MENU AND ESCAPE buttons on the control panel (B). Press and hold for 3 seconds to enter the linking mode.
| SERVICE | NEEDED |
C | SYSTEM | UPDATE |
6.Once the link has been confirmed, press the OK button on the generator control panel to exit or the control board will turn off linking after 5 minutes. The generator will now communicate with the wireless monitor.
NOTICE It may take up to 1 minute for the monitor to begin displaying the generator status correctly.
B |
B |
37
