Standard Operation:
Wireless Monitor Status LED’s
t 5IFXJSFMFTTNPOJUPSSFDFJWFTEBUBGSPNUIFHFOFSBUPS every 10 minutes and displays the generator status through 3 LED’s.
t 1SFTTJOHUIFSYSTEM UPDATE button will provide current generator status by flashing the status LED’s. When pressed, all 3 LEDs will flash until the generator status is received.
NOTICE Generator control panel must be in AUTO mode or no communication with monitor will occur.
t *OPSEFSUPDPOTFSWFQPXFSBOEUPFYUFOECBUUFSZMJGF the LED’s are not lit continuously; instead they are briefly flashed as indicated below.
NOTICE During the weekly exercise cycle, the generator will run for 20 minutes, but it will not supply power to the home. During the exercise cycle, the monitor will continue blinking the GENERATOR READY green LED.
t
t
t
NOTICE None of the conditions on the display unit can be cleared at the wireless monitor. All alerts must be cleared at the generator control panel.
NOTICE Service conditions will only be displayed on the basic monitor when the control board is placed in AUTO mode.
Other:
LED Lighting Codes
t #BUUFSJFT*OTFSUFEGENERATOR READY LED will light for 5 seconds.
t
NOTICE Communication lost issues can typically be resolved by moving the wireless monitor closer, within the home, to the standby generator.
t
Installation Inspection
Before placing the generator system into service, inspect the entire installation carefully.
This completes the installation and
38